Top Innovations SP-350 User Manual download pdf (Page 7)

STEAMER OPERATION

Set the unit on the floor and remove the water

container.

Check the inside of the container the sediment. If

present rinse the container and following the

Removing Mineral Buildup procedure

found

later in

this manual.

Turn the container upside down and push the plunger

valve open and allow to close two or three times to

insure it is functioning smoothly.

CAUTION: DO NOT PULL ON THE PLUNGER

VALVE OR YOU MAY ACCIDENTALLY REMOVE

IT AND THE WATER TANK WILL NOT FUNCTION

PROPERLY.

If the plunger is removed or falls out of the from the

valve cap assembly please refer to theReassembling

The Water Tank Valve Cap procedure later in this

manual.

STEP

FILLING

THE

WATER

CONTAINER

NOTE: USE OF DEMATERIALIZED OR DISTILLED

WATER IS HIGHLY RECOMMENDED.

Insure the unit is unplugged.

Remove the water container with the handle

and

turn

upside

dow

Turn the water facet in

you

sink

mild stream

While depressing the valve in the center of the base,

fill the tank with cool water through the opening.

NOTE: DO NOT FILL THE CONTAINER WITH HOT

WATER.

Release the valve and install water tank

the base.

STEP

OPERATING THE STEAMER

Ensure the ON/OFF switch is in the OFF position.

Plug the steamer cord into

normal

electrical

outlet or approved extension cord.

Turn the ON/OFF switch to the

position.

The switch will light when electricity is

connected.

Steam will be produced from the nozzle in a few

seconds.

CAUTION: DO NOT ALLOW THE CONTAINER TO

BECOME DRY DURING OPERATION, AS THIS WILL

SHORTEN THE LIFE OF THE STEAMER.

STEP 1 - PREPARATION FOR USE

P.6

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

Top Innovations SP-350 User Manual Page 7

Comments to this Manuals